Bracelet

How to maintain the chain, regret it if you don’t see it

by:JunQi     2021-09-30
The hardware chain is generally a metal link or ring, which is mostly used for mechanical transmission and traction. -shaped objects used to obstruct traffic passages (such as at the entrance of streets, rivers or harbors), chains used for mechanical transmission. So, do you know what are the techniques for chain maintenance? Don't panic, listen to what the editor says!   1. The sprocket should be installed on the shaft without skew and swing. In the same transmission assembly, the end faces of the two sprockets should be in the same plane. When the center distance of the sprocket is below 0, 5 meters, the allowable deviation is 1 mm; when the center distance of the sprocket is above 0, 5 meters, the allowable deviation is 2 Mm. However, it is not allowed to rub the side of the sprocket teeth. If the two wheels offset too much, it will easily cause chain disconnection and accelerated wear. When replacing the sprocket, you must pay attention to check and adjust the offset.  2. The tightness of the chain should be appropriate. Too tight increases power consumption and bearings are easy to wear; too loose chain is easy to jump and fall off. The tightness of the chain is as follows: lifted or pressed down from the middle of the chain, the center distance between the two sprockets is about 2-3cm.   3. The new chain is too long or stretched after use, making it difficult to adjust. You can remove the chain link depending on the situation, but it must be an even number. The chain link should pass through the back of the chain, the lock piece should be inserted outside, and the opening of the lock piece should face the opposite direction of rotation.   4. After the sprocket is severely worn, the new sprocket and the new chain should be replaced at the same time to ensure good meshing. It is not possible to just replace a new chain or a new sprocket alone. Otherwise it will cause poor meshing and accelerate the wear of the new chain or new sprocket. When the tooth surface of the sprocket is worn to a certain degree, it should be turned over and used in time (referring to the sprocket used with adjustable surface). To extend the use time.  5. The old chain cannot be mixed with part of the new chain, otherwise it is easy to produce an impact in the transmission and break the chain.   6. The chain should be filled with lubricating oil in time during work. The lubricating oil must enter the matching gap between the roller and the inner sleeve to improve working conditions and reduce wear.  The editor reminds you that when the machine is stored for a long time, the chain should be removed and cleaned with kerosene or diesel, and then coated with oil or butter and stored in a dry place to prevent corrosion.
Dongguan JunQi Hardware Manufacturing co.,Ltd promises that we will manufature our products in accordance with the strictest quality standards.
Our vision serves as the framework for our custom belt buckle makers and guides every aspect of our business by describing what we need to accomplish in order to continue achieving sustainable, quality growth.
Dongguan JunQi Hardware Manufacturing co.,Ltd, a manufacturer of custom belt buckle makers, might emphasize less hassle or less wasted time rather than emphasizing reliability or quality.
We should take a step back to review how JunQi approach tracking, implementing, and communicating compliance-related changes and attempt to identify areas of improvement in their processes.
It is never too late to have a new mindset and to get things moving in the right direction. Choose Dongguan JunQi Hardware Manufacturing co.,Ltd to be your quality provider.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...